Feature:
* Waterproof–Especially design for outdoor . 140 decibel alarm is loud enough to make a would be intruder think twice about
entering through your door and alert your neighbors of a possible break-in.
* Easy to use four-digit keypad for programming your custom pin – easy access buttons and controls for simple operation.
* Easy to install, simply mount using the provided mounting plate for temporary or permanent installation (double-sided tape and
screws provided).
* Features “Away” and Home” modes – both chime and alarm modes for when you are home or away as well as instant or delayed alarm.
* Battery powered so there is no need for wiring – requires 4 AAA batteries .
HOW TO USE IT
1)Insert or replace batteries:
a.Main unit
Open the battery compartment using a tool.
Insert 4 AAA batteries observing the correct polarity indicated.
Close the battery cover.
b.Remote control
One CR2032 cell button battery is included in remote control. Once this battery is out of order, change it for a new one by removing the battery compartment panel and replace by a new CR2032 cell button battery.
2)Installation
Use 3M tape to stick main unit and magnet on the door or window.
Install main unit on the fix part of door or window
Install the magnet on the moving part of door or window
3)How to use
a.Password setting and recovery
- Original password: 1234
- Change the password:
Step1: Enter the Original password 1234, a beep sound:
Step 2: Long press the button “1“, red light appears
Step 3: Enter your new password, long press button“1“, red light flash
3 times means change successfully: If continuous beep sound means
Change the password not success, repeat the above steps.
-Factory Reset:
Press the button“1“,and button”2“ at the same time until there is a beep sound
Note: the password cannot be changed via the remote control
Post time: Apr-13-2020
